Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 707 / 746

Appendix 1 Internal Memory
A1-16
•
Address $s64
It is possible to add the repeat function to the switch without repeat function.
Set a number other than [0] in the address $s64 for ON macro of the switch.
•
Address $s65
It is possible to prohibit the repeat function to the switch with repeat function.
Set a number other than [0] in the address $s65 for ON macro of the switch.
•
Address $s66
It is possible to repeat ON macro of the switch. Set a number other than [0]
in the address $s66 for ON macro.
Example:
Set ON macro of the switch as shown below.
$u100 = $u100 + 1
$s66 = 1
RET
While the switch is held down, $u100 is continuously incremented.
•
Address $s72
Contains the result of the macro command for system call.
[0]: Normal termination
[Other than 0] (normally
−
1): Error (ex.: the second screen setting)
•
Address $s73
Contains the result of the switch function when the [SWRET] command is
used for ON macro of the switch.
[0]: Normal termination
[Other than 0] (normally
−
1): Error
Use this address when the next operation should vary depending on the
result of the switch function.
•
Address $s76
If a keypad for entry mode is placed on an overlap, it is possible to turn OFF
the overlap with the [ENT] key of a keypad. To prohibit the above function,
use this memory address.
[0]: Overlap AUTO OFF
[Other than 0] Overlap AUTO OFF prohibited
For more information, refer to “Chapter 7 Entry Mode.”
•
Address $s77
When a value other than [0] is set, the exclusive overlap function is set.
For more information, refer to “Chapter 2 Overlap.”
Before executing ON macro, the system clears addresses $s64 to 66 to [0].
For these addresses, set [1] as necessary. The switch repeat function is
prohibited when it is not possible even if the macro command is executed.
(Ex.: The block number has reached the maximum value by the “+ Block”
switch.)