Gira CO2-Sensor, Руководство пользователя

Страница: 50 / 171

Order No. 2104 ..
- Transmit value on = Rising edge
- Value configured in the ETS for rising edge = 17
- Step width = 5
Figure 10: Example to change the value for dimming value transmitter
i There is no value over- or underrun on adjustment. If, during an adjustment, the maximum
or minimum value is reached (see Table 1), no more telegrams are transmitted.
i To ensure that, during a value adjustment, for example the controlled lighting switches off
or switches on at the maximum, the limit values (e.g. the values "0" or "255") are always
transmitted when the limits of the adjustable range are reached. This also takes place
when the configured step width of these values is not immediately taken into account (see
example above: step width = 5; value "2" is transmitted, then value "0").
In this case, to ensure that the original starting value can be reset on resetting with a
change to the adjustment direction, the first value jump is not equal to the preset step width
(see example above: step width = 5; value "0" is transmitted, then values "2"; "7" etc.).
i The newly adjusted values are stored in RAM. After a device reset (bus voltage failure or
ETS programming operation), the adjusted values are replaced by the values originally
configured in the ETS.
Page 50 of 171
Software "KNX CO2 sensor"
Functional description