CHAP
. 8
GE Healthcare
Senographe 2000 D Acquisition System
REV 1
OM 5179217–1–100
91
3-1-1
How to read a bar code symbol
The Senographe 2000 D bar code scanner is simple to use – just aim and shoot. Before using it,
make sure all cable connections are secure.
1. Hold the scanner handle horizontally (Figure 3 – ) directly over the bar code.
Figure 4 – Sample bar code symbol (code 128)
2. Press the scanner trigger located below the scanner handle: the scan red LED beam lights. The
scanner has successfully read the symbol if:
D
You hear a beep.
D
The LED beam turns off.
D
The handle light turns red.
3-1-2
Set default configuration
The scanner should already be configured. If not, programming the scanner is easy. You just scan bar
code menus.
In case you need to reset the bar code scanner to the supported AWS configuration, follow the steps
below:
1. Reset the bar code scanner to the factory settings. Wait until you hear 3 beeps.
2. Start Settings . You shall hear 2 beeps.
3. Set Full ASCII transmission to allow extended Code 39 characters transmission.
4. Set Extended Full ASCII to allow Function keys transmission on two characters.
FOR
TRAINING
PURPOSES
ONLY!
NOTE:
Once
downloaded,
this
document
is
UNCONTROLLED,
and
therefore
may
not
be
the
latest
revision.
Always
confirm
revision
status
against
a
validated
source
(ie
CDL).
