ETC Emphasis Lighting Control System, Руководство пользователя

Страница: 249 / 292

C
Lighting Playback Controllers 239
Step 8: Using four 10-32x1/2” bolts (and threaded clips, if necessary), loosely attach the
two slider brackets to rear holes in the rack that are opposite those holes used to
mount the front of the LPC. Do not secure yet.
Step 9: Line up the slider brackets with the rear brackets on each side of the LPC. The
threaded studs on the rear bracket should fit into the slider bracket slots. Attach
each rear bracket to a slider using two 10-32x3/8” screws each. The screws fit
through slots in the brackets and into threaded slider bracket holes.
Step 10: Tighten all bolts so that the assembly is level and secure.
Surface-mount Installation
The Express LPC may be mounted to a vertical surface, or above or below a horizontal
surface. Four feet, two brackets and four screws (for mounting the brackets to the LPC) are
provided. You will need to provide the screws and anchors (if necessary) for
mounting the brackets and LPC to the surface.
Surface-mount the Express LPC above a horizontal or to a vertical surface:
Step 1: Remove all mounting hardware from the plastic bag.
Step 2: Securely attach the four rubber bumpers to threaded holes in the bottom of the
LPC using 4-40x3/8” screws.
Step 3: Securely attach the two L-brackets to the side panels of the LPC as shown
above, using two 6-32x1/4” flathead screws each. Choose the bracket holes
closest to its bend.
Step 4: Place the LPC on the mounting surface. Mark the surface through the mounting
holes in each bracket. Remove the LPC.
Step 5: Drill holes at the marks of the appropriate diameter for the mounting anchors/
screws you have provided.
Step 6: Securely attach the LPC to the mounting surface.
Surface-mount the Express LPC below a horizontal surface:
Step 1: Remove all mounting hardware from the plastic bag.
Step 2: Securely attach the four rubber bumpers to threaded holes in the top of the LPC
using double-sided tape (not provided with LPC).
Step 3: Securely attach the two L-brackets to the side panels of the LPC 180° from the
bracket position illustrated above (the mounting flange should face the top of the
(2) 6-32 x 1/4” flathead
(2) 6-32 x 1/4” flathead