Endress+Hauser Proline Promass Q 500, Руководство по эксплуатации

Страница: 143 / 280

Proline Promass Q 500 PROFIBUS PA Commissioning
Hauser 143
Device alarm simulation →  144
Diagnostic event category →  144
Diagnostic event simulation →  144
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Assign simulation process variable – Select a process variable for
the simulation process that is
activated. • Off
• Mass flow
• Volume flow
• Corrected volume
flow
• Density
• Reference density
• Temperature
• Concentration
*
• Target mass flow
*
• Carrier mass flow
*
Off
Process variable value One of the following options is
selected in the
Assign
simulation process variable
parameter (→  143):
• Mass flow
• Volume flow
• Corrected volume flow
• Density
• Reference density
• Temperature
• Concentration
*
• Target mass flow
*
• Carrier mass flow
*
Enter the simulation value for
the selected process variable. Depends on the
process variable
selected 0
Status input simulation – Switch simulation of the status
input on and off. • Off
• On Off
Input signal level In the Status input simulation
parameter, the On option is
selected.
Select the signal level for the
simulation of the status input. • High
• Low High
Current input 1 to n simulation – Switch simulation of the
current input on and off. • Off
• On Off
Value current input 1 to n In the Current input 1 to n
simulation parameter, the On
option is selected.
Enter the current value for
simulation. 0 to 22.5 mA 0 mA
Current output 1 to n simulation – Switch the simulation of the
current output on and off. • Off
• On Off
Value current output 1 to n In the Current output 1 to n
simulation parameter, the On
option is selected.
Enter the current value for
simulation. 3.59 to 22.5 mA 3.59 mA
Frequency output simulation 1 to n In the Operating mode
parameter, the Frequency
option is selected.
Switch the simulation of the
frequency output on and off. • Off
• On Off
Frequency value 1 to n In the Frequency output
simulation 1 to n parameter,
the On option is selected.
Enter the frequency value for
the simulation. 0.0 to 12 500.0 Hz 0.0 Hz