Endress+Hauser Proline Promass Q 500, Руководство по эксплуатации

Страница: 118 / 280

Commissioning Proline Promass Q 500 PROFIBUS PA
118 Hauser
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Measuring value at maximum
frequency In the Operating mode
parameter, the Frequency
option is selected and one of
the following options is
selected in the
Assign
frequency output parameter
(→  116):
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
• Density
• Reference density
• Concentration
*
• Temperature
• Carrier pipe temperature
*
• Electronic temperature
• Oscillation frequency 0
• Frequency fluctuation 0
• Oscillation amplitude 0
*
• Oscillation damping 0
• Oscillation damping
fluctuation 0
• Signal asymmetry
• Exciter current 0
Enter measured value for
maximum frequency. Signed floating-point
number Depends on country
and nominal
diameter
Failure mode In the Operating mode
parameter, the Frequency
option is selected and one of
the following options is
selected in the
Assign
frequency output parameter
(→  116):
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
• Density
• Reference density
• Concentration
*
• Temperature
• Carrier pipe temperature
*
• Electronic temperature
• Oscillation frequency 0
• Frequency fluctuation 0
• Oscillation amplitude 0
*
• Oscillation damping 0
• Oscillation damping
fluctuation 0
• Signal asymmetry
• Exciter current 0
Define output behavior in
alarm condition. • Actual value
• Defined value
• 0 Hz 0 Hz