Endress+Hauser Proline Promass Q 500, Руководство по эксплуатации

Страница: 123 / 280

Proline Promass Q 500 PROFIBUS PA Commissioning
Hauser 123
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Relay output function – Select the function for the
relay output. • Closed
• Open
• Diagnostic
behavior
• Limit
• Flow direction
check
• Digital Output
Closed
Terminal number – Shows the terminal numbers
used by the relay output
module. • Not used
• 24-25 (I/O 2) –
Assign flow direction check In the Relay output function
parameter, the Flow direction
check option is selected.
Select process variable for flow
direction monitoring. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
Mass flow
Assign limit In the Relay output function
parameter, the Limit option is
selected.
Select process variable for limit
function. • Mass flow
• Volume flow
• Corrected volume
flow
• Target mass flow
*
• Carrier mass flow
*
• Density
• Reference density
• Dynamic viscosity
• Concentration
*
• Kinematic viscosity
• Temp.
compensated
dynamic viscosity
• Temp.
compensated
kinematic viscosity
• Temperature
• Oscillation
damping
• Totalizer 1
• Totalizer 2
• Totalizer 3
Mass flow
Assign diagnostic behavior In the Relay output function
parameter, the Diagnostic
behavior option is selected.
Select diagnostic behavior for
switch output. • Alarm
• Alarm or warning
• Warning Alarm
Assign status In the Relay output function
parameter, the Digital Output
option is selected.
Select device status for switch
output. • Partially filled pipe
detection
• Low flow cut off
• Digital output 4
Partially filled pipe
detection
Switch-off value In the Relay output function
parameter, the Limit option is
selected.
Enter measured value for the
switch-off point. Signed floating-point
number Country-specific:
• 0 kg/h
• 0 lb/min
Switch-off delay In the Relay output function
parameter, the Limit option is
selected.
Define delay for the switch-off
of status output. 0.0 to 100.0 s 0.0 s
Switch-on value In the Relay output function
parameter, the Limit option is
selected.
Enter measured value for the
switch-on point. Signed floating-point
number Country-specific:
• 0 kg/h
• 0 lb/min