VPN
Configuring a Site-to-Site VPN
Cisco ISA500 Series Integrated Security Appliances Administration Guide
292
8
General Site-to-Site VPN Settings
STEP 1
Click
VPN > Site-to-Site > IPsec Policies
.
The IPsec Policies window opens. All existing IPsec VPN policies are listed in the
table. The following information is displayed:
•
Name:
The name of the IPsec VPN policy.
•
Enable:
Shows if the IPsec VPN policy is enabled or disabled.
•
Status:
Shows if the IPsec VPN tunnel is connected or disconnected.
•
WAN Interface:
The WAN port that traffic passes through over the IPsec
VPN tunnel.
•
Peers:
The IP address of the remote peer.
•
Local:
The local network of the local peer.
•
Remote:
The remote network of the remote peer.
•
IKE:
The IKE policy used for the IPsec VPN policy.
•
Transform:
The transform set used for the IPsec VPN policy.
STEP 2
Click
On
to enable site-to-site VPN, or click
Off
to disable it.
NOTE:
Enabling the Site-to-Site VPN feature will disable the Teleworker VPN
Client feature.
STEP 3
If you enable site-to-site VPN, perform the following actions:
•
To add a new IPsec VPN policy, click
Add
. See
.
•
To edit an existing IPsec VPN policy, click the
Edit
(x) icon.
•
To delete an IPsec VPN policy, click the
Delete
(x) icon.
•
To delete multiple IPsec VPN policies, check them and click
Delete
.
•
To enable an IPsec VPN policy, check the box in the
Enable
column.
•
To manually establish a VPN tunnel, click the
Connect
icon for an enabled
IPsec VPN policy.
•
To manually terminate a VPN connection, click the
Disconnect
icon.
•
To refresh the data for site-to-site VPN, click
Refresh
.
