Mechanical handling
X90 mobile system User's manual V 1.20 - Translation of the original manual
29
4.3.3 Mating connector X1 - Accessory removal
All cable ties / cable clamps must be removed first.
The wire cap is unlocked by pressing down on the fastening clip (with a screwdriver, for example) and then rotating
the black latch down 90°.
Figure 20: Pressing on the fastening clip
Figure 21: Rotating the latch
To remove the wire cap from mating connector X1, the two locking points must be disengaged with a screwdriver.
This is done by pressing the screwdriver into one of the two slots and simultaneously pressing the wire cap in
the opposite direction. This procedure must then be repeated on the other side of the wire cap. The wire cap can
now easily be removed.
Figure 22: Removing the wire cap
To remove the cables, the gray latch must first be pulled out (with a screwdriver, for example).
Figure 23: Unlocking mating connector X1
