AudioCodes Mediapack mp-11x, Руководство пользователя

Страница: 48 / 390

SIP User's Manual 48 Document #: LTRT-65409
MediaPack Series
4.3 Assigning an IP Address
To assign the gateway an IP address, use one of the following methods:
„ HTTP using a Web browser (refer to 'Assigning an IP Address Using HTTP' on page
48 ).
„ BootP (refer to 'Assigning an IP Address Using BootP' on page 49 ).
„ Voice Menu using a standard touch-tone telephone connected to one of the FXS
analog ports (refer to Assigning an IP Address Using the Voice Menu Guidance on
page
50 ). This method doesn’t apply to FXO modules.
„ Embedded Command Line Interface (CLI) accessed via RS-232 or Telnet (refer to
'Assigning an IP Address Using the CLI' on page
51 ).
„ Dynamic Host Control Protocol (DHCP) (refer to the
SIP Series Reference Manual
).
Use the hardware Reset button at any time to restore the gateway's networking parameters
to their factory default values (refer to 'Restoring Default Settings' on page
241 ).
4.3.1 Assigning an IP Address Using HTTP
You can assign the gateway an IP address using the gateway's HTTP-based Embedded
Web Server.
¾
To assign an IP address using HTTP, take these 9 steps:
1.
Disconnect the gateway from the network and reconnect it to a PC using one of the
following two methods:
•
Connect the network interface on your PC to a port on a network hub / switch,
using a standard Ethernet cable. Connect the gateway to another port on the
same network hub / switch, using a second standard Ethernet cable.
•
Connect the network interface on your PC directly to the gateway, using an
Ethernet cross-over cable.
2.
Change your PC’s IP address and subnet mask to correspond with the gateway's
factory default IP address and subnet mask (for default IP addresses, refer to 'Getting
Started' on page
45 ).
3.
Access the gateway's Embedded Web Server (refer to 'Accessing the Embedded Web
Server' on page
58 ).
4.
Access the ‘Quick Setup’ screen by clicking the
Quick Setup
menu.
5.
Define the gateway's ‘IP Address’, ‘Subnet Mask’, and ‘Default Gateway IP Address’
fields to correspond with your network IP settings.
6.
Click the
Reset
button, and then at the prompt, click
OK;
the gateway applies the
changes and restarts.
7.
Disconnect your PC from the gateway or from the hub / switch (depending on the
connection method used in Step 1).