AudioCodes Mediapack mp-11x, Руководство пользователя

Страница: 260 / 390

SIP User's Manual 260 Document #: LTRT-65409
MediaPack Series
Table 6-1: Networking Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
NoOpInterval
Defines the time interval in which RTP or T.38 No-Op packets are sent in
the case of silence (no RTP / T.38 traffic) when No-Op packet
transmission is enabled.
The valid range is 20 to 65,000 msec. The default is 10,000.
Note:
To enable No-Op packet transmission, use the NoOpEnable
parameter.
RTPNoOpInterval
This parameter is obsolete; use the parameter NoOpInterval.
RTPNoOpPayloadType
Determines the payload type of No-Op packets.
the valid range is 96 to 127 (for the range for Dynamic RTP Payload
Type for all types of non hard-coded RTP Payload types, refer to RFC
3551). The default value is 120.
Note:
When defining this parameter, ensure that it doesn't cause
collision with other payload types.
EnableDetectRemoteMA
CChange
Changes the RTP packets according to the MAC address of received
RTP packets and according to Gratuitous Address Resolution Protocol
(GARP) messages.
ƒ
[0]
= nothing is changed.
ƒ
[1]
= If the gateway receives RTP packets with a different source
MAC address (than the MAC address of the transmitted RTP
packets), then it sends RTP packets to this MAC address and
removes this IP entry from the gateway's ARP cache table.
ƒ
[2]
= The gateway uses the received GARP packets to change the
MAC address of the transmitted RTP packets.
ƒ
[3]
= both 1 and 2 options above are used (default).
StaticNatIP
For a description of this parameter, refer to 'Configuring the IP Settings'
on page
164 .
SyslogServerIP
For a description of this parameter, refer to 'Configuring the Management
Settings' on page
208 .
SyslogServerPort
For a description of this parameter, refer to 'Configuring the Management
Settings' on page
208 .
EnableSyslog
For a description of this parameter, refer to 'Configuring the Management
Settings' on page
208 .
BaseUDPport
For a description of this parameter, refer to 'Configuring the RTP / RTCP
Settings' on page
183 .
RemoteBaseUDPPort
For a description of this parameter, refer to 'Configuring the RTP / RTCP
Settings' on page
183 .
L1L1ComplexTxUDPPort
For a description of this parameter, refer to 'Configuring the RTP / RTCP
Settings' on page
183 .
L1L1ComplexRxUDPPort
For a description of this parameter, refer to 'Configuring the RTP / RTCP
Settings' on page
183 .
NTPServerIP
For a description of this parameter, refer to 'Configuring the Application
Settings' on page
168 .
NTPServerUTCOffset
For a description of this parameter, refer to 'Configuring the Application
Settings' on page
168 .