AudioCodes Mediapack mp-11x, Руководство пользователя

Страница: 112 / 390

SIP User's Manual 112 Document #: LTRT-65409
MediaPack Series
Table 5-13: Supplementary Services Parameters
Parameter Description
Caller ID Type
[CallerIDType]
Defines one of the following standards for detection (FXO) and generation
(FXS) of Caller ID, and detection (FXO) generation (FXS) of MWI (when
specified) signals:
ƒ
[0]
Bellcore = Caller ID and MWI (default)
ƒ
[1]
ETSI = Caller ID and MWI
ƒ
[2]
NTT
ƒ
[4]
Britain
ƒ
[16]
DTMF ETSI
ƒ
[17]
Denmark = Caller ID and MWI
ƒ
[18]
India
ƒ
[19]
Brazil
Notes:
ƒ
Typically, the Caller ID signals are generated/detected between the first
and second rings. However, sometimes the Caller ID is detected before
the first ring signal (in such a scenario, configure RingsBeforeCallerID
to 0).
ƒ
Caller ID detection for Britain [4] is not supported on the gateway’s FXO
ports. Only FXS ports can generate the Britain [4] Caller ID.
ƒ
To select the Bellcore Caller ID sub standard, use the parameter
BellcoreCallerIDTypeOneSubStandard. To select the ETSI Caller ID
substandard, use the parameter ETSICallerIDTypeOneSubStandard.
ƒ
To select the Bellcore MWI sub standard, use the parameter
BellcoreVMWITypeOneStandard. To select the ETSI MWI sub
standard, use the parameter ETSIVMWITypeOneStandard.
Hook-Flash Code
[HookFlashCode]
Determines a digit pattern which, when received from the Tel side,
indicates a Hook Flash event. The valid range is a 25-character string.
MWI Parameters
Enable MWI
[EnableMWI]
Enable MWI (Message Waiting Indication).
ƒ
[0]
Disable = Disabled (default).
ƒ
[1]
Enable = MWI service is enabled.
Notes:
ƒ
This parameter is applicable only to FXS modules.
ƒ
The gateway supports only the reception of SIP MWI NOTIFY
messages (the gateway doesn't generate these messages).
For detailed information on MWI, refer to Message Waiting Indication
on page
360 .
MWI Analog Lamp
[MWIAnalogLamp]
ƒ
[0]
Disable = Disable (default).
ƒ
[1]
Enable = Enables visual Message Waiting Indication. Supplies line
voltage of approximately 100 VDC to activate the phone's lamp.
Note:
This parameter is applicable only to FXS modules.