AudioCodes Mediapack mp-11x, Руководство пользователя

Страница: 144 / 390

SIP User's Manual 144 Document #: LTRT-65409
MediaPack Series
4.
From the 'Profile Preference' drop-down list, select the preference (1-20) of the current
Profile. The preference option is used to determine the priority of the Profile. Where
'20' is the highest preference value. If both IP and Tel profiles apply to the same call,
the coders and other common parameters (noted by an asterisk in the description of
the parameter IPProfile) of the preferred Profile are applied to that call. If the
Preference of the Tel and IP Profiles is identical, the Tel Profile parameters are
applied.
Note:
If the coder lists of both IP and Tel Profiles apply to the same call, an
intersection of the coders is performed (i.e., only common coders remain). The order
of the coders is determined by the preference.
5.
Configure the Profile's parameters according to your requirements. For detailed
information on each parameter, refer to the description of the screen in which it is
configured as an individual parameter.
6.
From the 'Coder Group' drop-down list, select the coder group you want to assign to
the Profile. You can select the gateway's default coders (refer to 'Coders' on page
92 )
or one of the coder groups you defined in the Coder Group Settings screen (refer to
'Coder Group Settings' on page
138 ).
7.
Repeat steps 2 to 6 for the second to fifth IP Profiles (optional).
8.
Click the
Submit
button to save your changes.
9.
To save the changes to flash memory, refer to 'Saving Configuration' on page 238 .
5.5.6 Configuring the Endpoint Phone Numbers
From the 'Endpoint Phone Number Table' screen you can enable and assign telephone
numbers, hunt groups (optional), and profiles to the VoIP gateway ports. You can also
configure the Endpoint Phone Numbers using the
ini
file parameter TrunkGroup (refer to
'Number Manipulation and Routing Parameters' on page 304 ).
¾
To configure the Endpoint Phone Number table, take these 4
steps:
1.
Open the ‘Endpoint Phone Number Table’ screen (
Protocol Management
menu >
Endpoint Phone Numbers
).
Figure 5-27: Endpoint Phone Number Table Screen
2.
Configure the endpoint phone numbers according to the table below. You must enter a
number in the' Phone Number' fields for each port that you want to use.
3.
Click the
Submit
button to save your changes, or click the
Register
or
Un-Register
buttons to save your changes and to register / unregister to a Proxy / Registrar.
4.
To save the changes to the flash memory, refer to 'Saving Configuration' on page 238 .