AudioCodes Mediapack mp-11x, Руководство пользователя

Страница: 378 / 390

SIP User's Manual 378 Document #: LTRT-65409
MediaPack Series
b.
Use the ‘Add a new table entry’ pane to add the routing rules shown in the
following table:
Destination IP
Address
Destination Mask
Gateway IP
Address
Hop Count Network Type
130.33.4.6 255.255.255.255 10.32.0.1 20 Control
83.4.87.6 255.255.255.0 10.31.0.1 20 OAM
a.
Click the
Submit
button to save your changes.
6.
Save your changes to flash memory (refer to 'Saving Configuration' on page 238 ).
7.
Reset the gateway (refer to 'Resetting the Gateway' on page 239 ).
8.9.3.2 Integrating Using the ini File
The procedure below describes how to integrate the gateway into a VLAN and multiple IPs
network using the
ini
file.
¾
To integrate the gateway into a VLAN and multiple IPs network
using the ini file, take these 3 steps:
1.
Prepare an
ini
file with relevant parameters. Refer to the following notes:
•
If the BootP/TFTP utility and the OAM interface are located in the same network,
the Native VLAN ID (VlanNativeVlanId) must be equal to the OAM VLAN ID
(VlanOamVlanId), which in turn must be equal to the PVID of the switch port to
which the gateway is connected. Therefore, set the PVID of the switch port to 4
(in this example).
•
Configure the OAM parameters (LocalOAMPAddress, LocalOAMSubnetMask
and LocalOAMDefaultGW) only if the OAM networking parameters are different
from the networking parameters used in the Single IP Network mode.
•
The IP Routing table is required to define static routing rules for the OAM and
Control networks since a default gateway isn’t supported for these networks.