AMS Neve AudioFile SC/X, Руководство пользователя

Страница: 255 / 391

AudioFile SCX user manual
255
Revision 0.91
replaced with the external timecode. The software will permit all the normal
standards to be used: 24, 25, 30, and 29.97 (drop frame) F.P.S. (frames per
second). The required rate can be selected from the Machine Defaults page
which is accessible from the main Defaults page. In addition, the machine
type and dropout limit are selected from this page.
Time can be entered/displayed as timecode or feet and frames.
A box is displayed with time fields expressed in hours, minutes and seconds
(timecode)
e.g. 01:17:24 10.00,
or (feet and frames),
e.g. 035631.23
Tenths of frames are preceded by a decimal point.
External operation provides the possibility of controlling another transport from
the Control Surface. The transport keys below the Softwheels can command
suitable machines via the RS422 serial ports at the rear of the mainframe.
When timecode is used, AudioFile SCX’s sample clock acts as SLAVE. This
applies even though AudioFile SCX may appear to be the MASTER when
controlling another machine. If no timecode is being fed into the system a
‘WAIT’ status message appears below the system time at the top right-hand
corner
to
‘EXT’ i
feren
an 1/2 frame synchronisation. The actual synchronisation time is short,
second, however, a further delay occurs while the audio
pre-loaded with data. If audio is played out against timecode
at crosses the 24 hour threshold. AudioFile
CX can be wound back to, for example, 23 hours, 59 minutes and 55
ode is entered the VCR starts, AudioFile SCX logs on
d the audio begins when the timecode start position is
Defaults Page and
-ROLL OVER
Operating in this mode will restrict the ability of AudioFile SCX to play up to
night ie all timecode must fall within a 24 hour period.
of the page. When good timecode is received the message changes
ndicating that the sampling clock is synchronised with the external
ce. This message appears when AudioFile SCX has achieved better re
th
approximately 1
racks are being t
there is approximately 3.5 seconds of delay between receipt of code and
audio starting to play.
When controlling multiple machines, the external timecode (and all external
machines) must be locked to video. The source of the timecode can be
selected as the master machine or as an independent external source.
Where recordings begin at a timecode close to zero hours, it may be
ecessary to perform a pre-roll th n
S
seconds. Once play m
o external timecode an t
reached. To enable a pre-roll up to midnight, enter the
croll down the options to ALLOW TIMECODE TO PRE s
MIDNIGHT and ensure YES is selected.
m id
Jan 2008