Emulator Support
Am186™CC/CH/CU Microcontrollers User’s Manual 4-5
4.3.2.18 S2–S0
The S2–S0 bus indicates the type of memory cycle in progress.
4.3.2.19 S6
The S6 signal is active from t
1
–t
4
on the microcontroller and signals a refresh or DMA
access.
4.3.2.20 SRDY
See “ARDY and SRDY” on page 4-3.
4.3.2.21 UCS
The system typically uses UCS as a FLASH or ROM chip select. Emulators use this to
determine when ROM accesses occur, and can intercept it for overlay memory purposes.
4.3.2.22 {UCSX8} and WLB
During processor reset, the UCSX8 pin configures the upper memory region for 8-bit
operation. The BSIZE8 signal unambiguously indicates the width of a memory region for a
given access.
4.3.2.23 WHB and WR
The emulator can intercept WHB and WR for use with overlay memory. Although most
emulators use S2–S0 to determine cycle type, some may use the WR signal to determine
when writes occur. This prevents the use of WR as a PIO when using the emulator.
4.3.2.24 WLB
4.3.2.25
WR
See “WHB and WR” .
4.3.3 Hardware-Related Considerations
■
Be sure to allow room for pucks and emulator heads on your target board.
■
The following PIO signals are multiplexed with alternate signals that may be used by
emulators: PIO8, PIO15, PIO33, PIO34, and PIO35. Consider any emulator
requirements for the alternate signals before using these pins as PIOs.
4.3.4 Comparison to Other Devices
■
Previous Am186 watchdog timer implementations required the application to disable the
watchdog timer to prevent watchdog time-outs while emulator code was executing. The
Am186CC/CH/CU watchdog timer does not have this limitation. A feature of the
watchdog timer allows ICE code to inhibit the count of the watchdog timer.
4.4 INITIALIZATION
On both external and internal reset, the following occurs:
■
Multiplexed pins used in emulation default to signals shown in Chapter 3, “System
Overview.”
Содержание Am186 CC
