2-13
SPEC
CABLE ROUTING DIAGRAM
EC240000
CABLE ROUTING DIAGRAM
1
Brake hose
2
Cable guide
3
“ENGINE STOP” button lead
4
Fuel tank breather hose
5
Clamp
6
Throttle cable
7
Air vent hose (right)
8
Air vent hose (left)
9
Transmission oil breather hose
0
Overflow hose
q
YPVS breather hose
w
Radiator breather hose
e
CDI magneto lead
r
Wireharness
A
Pass the throttle cable and
“ENGINE STOP” button lead
into the cable guide. Align
with the cable guide the
front end of the tape on the
throttle cable.
B
Pass the fuel tank breather
hose between the handlebar
and tension bar, then insert
its end into the hole of the
number plate.
C
Pass the throttle cable and
“ENGINE STOP” button lead
over the radiator hose.
D
Clamp the throttle cable,
“ENGINE STOP” button lead
and wireharness to the main
pipe. With the clamp ends
downward, tighten the throttle
cable to the extent that it
moves smoothly.
E
Clamp the “ENGINE STOP”
button lead (where there is no
protector), wireharness and
throttle cable all together to the
main pipe with the clamp ends
downward.
F
Clamp the CDI magneto lead
on the upper part of
the frame gusset at its
protecting tube.
G
Clamp the throttle cable and
wireharness to the main pipe.
With the clamp ends downward,
tighten the throttle cable to the
extent that it moves smoothly.
H
Pass the air vent hose at
the rear of the throttle cable.
I
Pass the transmission oil
breather hose, air vent hoses
and overflow hose between
the frame and connecting rod.
J
Pass the radiator breather
hose and YPVS breather hose
outside the engine bracket
and inside the down tube. Then
pass the radiator breather
hose inside the YPVS
breather hose.
K
Clamp the radiator breather
hose and CDI magneto lead
on the rear of the down-tube.
5NY-9-30-2B 5/23/01 8:03 PM Page 26
Summary of Contents for YZ125(P)/LC
Page 128: ...3 3 INSP ADJ MEMO...
Page 286: ...4 37 ENG CLUTCH AND PRIMARY DRIVEN GEAR 4 Install 9Plain washer 1 9Circlip 2...
Page 562: ...TUN MEMO...
Page 563: ......