Yamaha TT-R125E(R), Owner'S Service Manual

Page: 498 / 578

5 - 47
CHAS
6. Install:
TT-R125E
●
Start switch 1
●
Bolts (start switch) 2
●
Front brake cable 3
●
Clamp
NOTE:
Apply the lithium soap base grease on the
front brake cable end.
TT-R125LWE
●
Start switch 1
●
Brake master cylinder 2
●
Brake master cylinder bracket 3
●
Bolt (brake master cylinder bracket) 4
NOTE:
●
Install the bracket so that the arrow mark
a
face upward.
●
First tighten the bolts on the upper side of the
brake master cylinder bracket, and then
tighten the bolts on the lower side.
7. Install:
●
Engine stop switch 1
●
Clutch lever holder 2
●
Screws (clutch lever holder) 3
NOTE:
●
The engine stop switch and clutch lever
holder should be installed according to the
dimensions shown.
●
Pass the engine stop switch lead in the mid-
dle of the clutch lever holder.
8. Install:
●
Clutch cable 1
●
Clamp
NOTE:
Apply the lithium soap base grease on the
clutch cable end.
9. Adjust:
●
Brake lever free play
Refer to “FRONT BRAKE ADJUST-
MENT” section in the CHAPTER 3.
●
Clutch lever free play
Refer to “CLUTCH ADJUSTMENT”
section in the CHAPTER 3.
3
1
2
LS
T
R
.
.
4 Nm (0.4 m · kg, 2.9 ft · lb)
U P
3
2
4
4
a
1
T
R
.
.
9 Nm (0.9 m · kg, 6.5 ft · lb)
1
2
3
3
T
R
.
.
4 Nm (0.4 m · kg, 2.9 ft · lb)
HANDLEBAR