Media Types
47
"
Keep media between 35% and 85% relative humidity. Toner does
not adhere well to moist or wet paper.
Layered
Adhesive
Folded, creased, curled, embossed, warped, or wrinkled
Too slick, too coarse, or too textured
Different in texture (roughness) on the front and back
Too thin or too thick
Stuck together with static electricity
Composed of foil or gilt; too luminous
Heat sensitive or cannot withstand the fusing temperature
(180° C [356° F])
Irregularly shaped (not rectangular or not cut at right angles)
Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
Acidic
Any other media that is not approved
Thick Stock
Paper thicker than 90 g/m
2
(24 lb. bond) is referred to as thick stock. Test all
thick stock to ensure acceptable performance and to ensure that the image
does not shift.
"
43 lb. bond is also referred to as 90 lb. index stock.
DO NOT use thick stock that is
Mixed with any other media in the trays (as this will cause printer
misfeeding)
Capacity
Tray 1
Up to 50 thick stock sheets,
depending on their thickness
Tray 2
Not supported
Orientation
Face up
Driver Media Type
Thick
Weight
91 to 163 g/m² (25 to 43 lb. bond)
Duplexing
Not supported
Summary of Contents for Phaser 6120
