Xerox Phaser 6120, User Manual

Page: 24 / 174

Selecting Driver Options/Defaults (for Windows)
17
Selecting Driver Options/Defaults
(for Windows)
Before you start working with your printer, you are advised to verify/change
the default driver settings. Also, in case you have options installed, you
should enable the options in the driver.
Windows XP/Server 2003/2000/NT 4.0
1 Choose the driver’s properties as follows:
„ (Windows XP/Server 2003)
From the Start menu, choose Printers and Faxes to display the
Printers and Faxes directory. Right-click the Phaser 6120 PostScript
or Phaser 6120 PCL6 printer icon and choose Properties .
„ (Windows 2000/NT 4.0)
From the Start menu, choose Settings , and then Printers to display
the Printers directory. Right-click the Phaser 6120 PostScript or
Phaser 6120 PCL6 printer icon and choose Properties .
2 If you have installed options, proceed with the next step. Otherwise, skip
to step 9.
3 Select the Configure tab.
4 Check that the installed options are correctly listed. If not, proceed with
the next step. Otherwise, continue with step 8.
5 Click the Refresh button to automatically configure installed options.
"
The Refresh button is available only if bi-directional
communication is available with the printer; otherwise it is
grayed out.
6 From the Device Option list, select an option, one at a time, and then
select Enable or Disable from the Settings drop-down list.
"
If Printer Memory is selected, select 128 MB , 256 MB , 384 MB or
640 MB , according to the installed memory. The factory default
setting is 128 MB .
7 Click Apply .
"
Depending on the version of the operating system, Apply may not
appear. If this is the case, continue with the next step.
"
With Windows NT 4.0, right-click the Phaser 6120 PostScript or
the Phaser 6120 PCL6 printer icon in the Printers directory, and
then click
Document Defaults . Skip to step 10.
8 Select the General tab.