Network Connection
8
Setting the Address Manually
You may also manually change the printer’s IP address, subnet mask, and
gateway by using the following instructions. (For more information, see
Understanding the Ethernet Configuration Menus in the
Phaser 6120
Reference Guide
on the
Software and Documentation CD-ROM
.)
"
When the IP address is changed, add a new port or reinstall the
printer driver.
CAUTION
You should always notify the network administrator before changing the
printer’s IP address.
1
Turn on your PC and printer.
2
When the printer’s message window displays
READY
, set the IP address.
a
Select
Connection Setup
, and then press the
Menu/Select
key.
b
Select
Network Setup
, and then press the
Menu/Select
key.
c
Select
TCP/IP,
and then press the
Menu/Select
key.
d
Select IP Address, and then press the
Menu/Select
key.
e
Use the
Up
and
Down
keys to select the IP Address.
f
Use the
Right
and
Left
keys to move to the next set of numbers.
g
Repeat Steps e and f until you have selected the entire IP Address.
3
If you do not need to set the subnet mask or gateway, go to step 5.
To set the subnet mask, but not the default router, go to step 8.
To set the default router, follow these steps.
a
Select
Default Router
, and then press the
Menu/Select
key.
b
Use the
Up
and
Down
keys to select the Default Router numbers.
c
Use the
Right
and
Left
keys to move to the next set of numbers.
d
Repeat Steps and b and c until you have selected the entire Default
Router number.
Summary of Contents for Phaser 6120
