u-blox ZED-F9P Interface Description - Manual
Advance Information
CFG-RINV continued
Byte Offset
Number
Format
Scaling
Name
Unit
Description
1 + 1*N
U1
-
data
-
Data to store/stored in Remote Inventory.
End of repeated block
Bitfield flags
This graphic explains the bits of
flags
Name
Description
dump
Dump data at startup. Does not work if flag
binary
is set.
binary
Data is binary.
5.9.21 UBX-CFG-RST (0x06 0x04)
5.9.21.1 Reset Receiver / Clear Backup Data Structures
Message
UBX-CFG-RST
Description
Reset Receiver / Clear Backup Data Structures
Firmware
Supported on:
•
u-blox 9 with protocol version 27
Type
Command
Comment
Don't expect this message to be acknowledged by the receiver.
• Newer FW version won't acknowledge this message at all.
• Older FW version will acknowledge this message but the acknowledge may not be sent
completely before the receiver is reset.
Header
Class
ID
Length (Bytes)
Payload
Checksum
Message Structure
0xB5 0x62
0x06 0x04 4
see below
CK_A CK_B
Payload Contents:
Byte Offset
Number
Format
Scaling
Name
Unit
Description
0
X2
-
navBbrMask
-
BBR Sections to clear. The following Special Sets
apply:
0x0000 Hot start
0x0001 Warm start
0xFFFF Cold start (see
UBX-18010854 - R04
Advance Information
Page 76 of 259
