u-blox ZED-F9P, Interface Description

Page: 144 / 267

u-blox ZED-F9P Interface Description - Manual
Advance Information
Bitfield patchInfo
This graphic explains the bits of
patchInfo
Name Description
activated 1: the patch is active. 0: otherwise.
location
Indicates where the patch is stored. 0: eFuse, 1: ROM, 2: BBR, 3: file system.
5.13.9 UBX-MON-RF (0x0A 0x38)
5.13.9.1 RF information
Message
UBX-MON-RF
Description
RF information
Firmware
Supported on:
•
u-blox 9 with protocol version 27
Type
Periodic/Polled
Comment
Information for each RF block.
Header Class ID Length (Bytes) Payload Checksum
Message Structure
0xB5 0x62 0x0A 0x38 4 + 24*nBlocks
see below
CK_A CK_B
Payload Contents:
Byte Offset Number
Format
Scaling Name Unit Description
0 U1 -
version
- Message version (0x00 for this version)
1 U1 -
nBlocks
- The number of RF blocks included
2 U1[2] -
reserved1
- Reserved
Start of repeated block (nBlocks times)
4 + 24*N U1 -
blockId
- RF block id
5 + 24*N X1 -
flags
- Flags (see graphic below )
6 + 24*N U1 -
antStatus
- Status of the antenna supervisor state machine
(0x00=INIT,0x01=DONTKNOW,0x02=OK,
0x03=SHORT,0x04=OPEN)
7 + 24*N U1 -
antPower
- Current power status of antenna (0x00=OFF,
0x01=ON,0x02=DONTKNOW)
8 + 24*N U4 -
postStatus
- POST status word
12 + 24*N U1[4] -
reserved2
- Reserved
16 + 24*N U2 -
noisePerMS
- Noise level as measured by the GPS core
18 + 24*N U2 -
agcCnt
- AGC Monitor (counts SIGHI xor SIGLO, range 0
to 8191)
20 + 24*N U1 -
jamInd
- CW jamming indicator, scaled (0=no CW
jamming, 255 = strong CW jamming)
21 + 24*N I1 -
ofsI
- Imbalance of I-part of complex signal, scaled (-
128 = max. negative imbalance, 127 = max.
positive imbalance)
UBX-18010854 - R04 Advance Information Page 136 of 259