Toyota ZZT230 series, Repair Manual

Page: 586 / 821

4
Check side squib (RH).
Squib
(RH)
Airbag
Sensor
Assembly
ON
0
DLC3
CG
Tc
1101021
ABOII9
HIOIIIXI 1101070
DTC B011 1 144
DIAGNOSTICS
SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Turn the ignition switch to LOCK.
0�75
(b) Disconnect negative
{-)
terminal cable from the battery,
and wait at least for 90 seconds.
(c) Connect the front side airbag assembly
(RH)
connector.
(d) Connect negative (-) terminal cable to the battery, and
wait at least for 2 seconds.
CHECK:
(a} Turn the ignition switch to ON, and wait at least for 20 se­
conds.
(b) Clear the DTC stored in memory (See page Dl-326).
(c)
Turn
the ignition switch to LOCK, and wait at least for 20
seconds.
(d) Turn the ignition switch to or ON, and wait at least for 20
seconds.
(e) Check the DTC (See page Dl-326).
OK:
DTC
80111/44
Is not output.
HINT:
Codes other than code 60111/44 may be output at this time, but
they are not relevant to this check.
Replace side airbag assembly (RH).
From the resuhs of the above Inspection, the malfunctioning part can now
be
considered normal.
To make sure
of
this, use the simulation method to check.