Toyota ZZT230 series, Repair Manual

Page: 602 / 821

)
)
01-391
DIAGNOSTICS
SUPPLEMENTAL RESTRAINT SYSTEM
4
Check side squib (LH).
Afrbag
Sensor
Assembly
ON
0
DLC3
DTC 80117/45
"' =>
�
CG Tc
PREPARATION:
(a) Turn the ignition switch to LOCK.
(b) Disconnect negative (-) terminal cable from the battery,
and wait at least for 90 seconds.
{c) Connect the front side airbag assembly (LH} connector.
(d) Connect negative (-) terminal cable to the battery, and
wait at least for 2 seconds.
CHECK:
(a) Turn the ignition switch to ON, and wait at least for 20 se­
conds.
(b) Clear the DTC stored in memory
(See step 5 on page Dl-326).
(c) Tum the ignition switch to LOCK, and wait at least for 20
seconds.
(d) Tum the ignition switch to ON, and wait at least for 20 se·
conds.
(e) Check the DTC (See page Dl-326).
OK: DTC B0117/451s not output.
HINT:
Codes other than code 80117/45 may be output at this time, but
they are not relevant to this check.
Replace front side alrbag assembly
(LH).
From
the
results of the above Inspection, the
part can now
be
considered normal.
To
make
sure
of
this, use the simulation method to check. the malfunctioning part can not
be
detected
by the simulation method, replace all SRS components Including the wire harness.