Toyota ZZT230 series, Repair Manual

Page: 576 / 821

)
)
4
Check
P
squib.
PSquib
DLC3
CG
Tc
�·"'
MOll&
tilOIDO
H01075
Airbag
Sensor
Assembly
DTC 80107/51
DIAGNOSllCS
-
SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Turn
the i
gn
it
ion switch to LOCK.
Dl-365
(b) Disconnect negative (-) terminal cable from the battery,
and
wait at lea
st for 90 seconds.
(c) Connect the front passenger airbag assembly connector.
(d) Connect negative (-) terminal cable to the battery, and
wait at least for
2
seconds.
CHECK:
(a) Turn
the i
gn
i
t
i
on switch to ON, and wait at least for 20 se­
conds.
(b)
Clear
the
DTC
stored
in
memory
(See step 5 on page Dl-326).
(c) Turn the ignition switch to LOCK, and wait at least for
20
seconds.
(d) Turn the ignition switch to ON, and wait at least for 20 se­
conds.
(e) Check the DTC (See page Dl-326).
OK: DTC
80107/51
I
s not output.
HINT:
Codes other than code 80107/51 may be output at this time, but
they are not relevant to this check.
Replace front passenger alrbag assembly.
From the results of the above Inspection, the
can
now
be
considered normal,
To make sure of this, uss the simulation method
to check.
the
malfunctioning part can not
be
detected by
the
simulation
method, replace
all SRS
components Including the wire harness.