Toyota ZZT230 series, Repair Manual

Page: 21 / 821

IN-16
-
(h)
AIRBAG SENSOR ASSEMBLY
(1}
Never reuse the airbag sensor assembly involved
in a collision when the SAS has deployed.
(2) The connectors to the airbag sensor assembly
should be connected or disconnected with the sen­
sor mounted on the floor.
If
the connectors are con­
nected or disconnected while the airbag sensor as­
sembly is not mounted to the floor, it could cause
undesired ignition of the supplemental restraint sys­
tem.
(3}
Work must
be
started after
90
seconds from the
time the ignition switch is turned to the �LOCK� posi­
tion and the negative (-) terminal cable is discon­
nected from the battery, even if only loosing the set
bolts of the airbag sensor assembly.
(I)
WIRE HARNESS AND CONNECTOR
The SRS wire harness is Integrated with the instrument
panel wire harness assembly. All the connectors in the
syslem are a slandard yellow color. If lhe SRS wire har­
ness becomes disconnected or the connector becomes
broken due to an accident, etc., repair or replace it as
shown on page R8-72.