Toyota ZZT230 series, Repair Manual

Page: 415 / 821

Dl-204
-
AUTOMATIC
INSPECTION PROCEDURE
1
Read PNP, REVERSE, 2ND
and LOW signals.
When using TOYOTA hand-held
tester:
PREPARATION:
(a)
Remove the DLC3 cover.
(b) Connect a TOYOTA hand-held tester to the DLC3.
(c) Turn the ignition switch ON and
TOYOTA
hand-held tes-
ter main switch ON.
CHECK:
Shift lever into the
P,
R, N, D, 2 and L positions, and read the
NSW. REVERSE. 2ND DRIVE and
LOW
signals on the TOYO·
TA hand-held tester.
OK:
Shift position Signal
2 2ND OFF �ON
l
LOW OFF -}ON
D DRIVE OFF ---) ON
R
REVERSE OFF-;. ON
P. N NSWOFF -tON
When not using TOYOTA hand-held tester:
PREPARATION:
Turn the ignition switch ON.
CHECK:
Measure voltage between terminals
P. R.
N. D. 2 and L of ECM
and body ground when the shift lever is shifted to the following
positions.
OK:
Position
P-Body R-Body N-Body 0-Body 2-Body L-Body
ground ground ground ground ground ground
p
9-14V
o v o v o v o v o v
R
ov
9-14V
o v o v o v o v
N ov ov
9-14V
ov ov ov
D o v
O V O V 9-14V
o v o v
2
ov ov ov ov
9-14V
o v
L
o v o v o v
D V
ov
9-14V
HINT:
*: The voltage will drop slightly due to lighting up of the back up
light.
Check and replace the ECM (See page
tN-30).