Toshiba e-studio 211c, Operator'S Manual

Page: 47 / 225

1
2
3
4
5
6
7
8
9
10
11
12
3-4
SETTING OF BASIC COPY MODES
2. REDUCTION AND ENLARGEMENT COPYING
The built-in sensors automatically detect the size of the original(s) and calculate the reproduction ratio
using the specified paper size.
* It is not possible for the device to perform Automatic Magnification Selection with highly transparent
originals such as OHP films and tracing paper, wholly dark originals or originals with dark borders, or
irregular sized originals such as newspapers and magazines. For these types of originals, use the other
reduction/enlargement modes.
Original sizes for which Automatic Magnification Selection (automatic detection) is available
Page 2-9
* Set the size for the “OTHER” key as required ( Page 6-16). When the set paper is a standard size
other than LD, LG, LT or ST, you will select the OTHER key on the screen of step 3 below. Before
pressing it, you need to make the OTHER key recognize the same size as the paper that have been
set.
Using Automatic Magnification Selection (AMS)
Select other copy modes as required.
5
Press the START key.
1 Place paper in the drawer(s).
Page 2-4
3 Press the AMS key.
- OTHER key Page 6-16
4 Place the original(s).
Page 2-9
- The built-in sensors automatically detect the size of the
original(s) and compute the reproduction ratio using the speci-
fied paper size.
- If the following messages are shown, proceed as directed:
Change direction of original
Use reduced-size cassette
2 Press the desired drawer, then the ZOOM··· key.
- The copy paper size is selectable on the screen in step 3
as well.