Thermo Scientific Dionex, Operator'S Manual

Page: 83 / 228

5 • AE Analyzer Enclosure Description
Doc. 065250-06 03/2020
71
5.3.2 Power Outlet Strip
A power outlet strip with 10 AC outlets is installed inside the AE (see
Figure 5-3 ), in the rear-left corner. Power cords from all components (SP,
detector, pump, air conditioner, and so on) installed inside the AE or
mounted on the side of the AE are connected to these outlets. This allows
the AE main power switch (see
Figure 5-6 ) and
Emergency Off
switch
(see Figure 5-2 ) to control the power to all connected components.
5.3.3 Drip Tray and Liquid Drain
The drain lines from all modules installed inside the AE can be routed to
the AE drip tray. The drip tray collects any liquid that drains from these
lines, as well as any liquid that drains from other components in the AE.
The liquid in the drip tray exits the AE through the drain port. A drain line
can be connected to this port, if you want.
5.3.4 Liquid Leak Sensing
The leak sensors in the individual modules inside the AE provide leak
detection.
If the Dionex Integral system is equipped with an SP, an auxiliary leak
sensor (P/N 067728) can be installed in the AE drip tray and connected to
the SP electronics. If the auxiliary leak sensor becomes wet, it reports the
leak to Chromeleon 7 and an error message is displayed in the audit trail.