Thermo Scientific Dionex, Operator'S Manual

Page: 58 / 228

Dionex Integral Systems Operator’s Manual
46
Doc. 065250-06 03/2020
5. Plug the analog input cable (P/N 070171) into an analog input connector on
the main SP electronics board.
NOTE Although Analog Input 4 is usually reserved for
monitoring of the stir bar in the dilution vessel mixer
(see
Section 3.5.2 ), it can be used for a different function
by simply changing the position of a jumper on the main
SP electronics board. For instructions, see
“To change
the position of the Analog Input 4 jumper:” on page 47 .
6. Attach wires to the 2-position connector plug on the other end of the cable.
To attach a wire to the plug: Strip the end of the wire, insert it into the plug,
and use a screwdriver to tighten the locking screw.
7. Route the cable to the other device, and then connect the free ends of the wires
to the appropriate connector pins on the device.
8. Close and secure the SP service door.
9. If you removed the SP from the AE rear panel:
a. Lift up the SP, align the four hooks on the rear of the SP with the
mounting rails on the AE rear panel, and hang the SP on the rails.
b. Replace any modules that were removed from the lower shelf of the AE.
c. Replace the two access panels on the exterior of the AE.
10. Plug in the power cord and turn on the power.
11. Open the Chromeleon 7 Instrument Configuration Manager and open the SP
Properties dialog box. The check box for the connected analog input is
enabled on the Analog Inputs page. The name assigned to the input
corresponds to the number of the connector on the main SP electronics board.
12. Save the configuration.
13. Calibrate the analog input (see Section 10.10 ).
When attaching wires to the connector plug, be careful not to allow
stray strands of wire to short to an adjoining position on the
connector.