Thermo Scientific Dionex, Operator'S Manual

Page: 201 / 228

E • Peristaltic Pump Kit Installation Instructions
Doc. 065250-06 03/2020
189
the peristaltic tubing adapter set. Install the nut and ferrule on the
tubing as shown in
Figure E-9 .
13. If you removed the SP from the AE rear panel during this installation
procedure:
a. Lift up the SP, align the four hooks on the rear of the SP with the
mounting rails on the AE rear panel, and hang the SP on the rails.
b. Replace any modules that were removed from the lower shelf of
the AE.
c. Replace the two access panels on the exterior of the AE.
14. Plug in the power cord and turn on the power.
E.2.4 Configuring the Pump in Chromeleon 7
1. Start the Chromeleon 7 Instrument Configuration Manager.
2. Double-click the SP icon under the instrument name. The Properties
dialog box appears.
3. Click the Solenoids tab.
4. Select SV9 (when configuring the first or only pump) or SV10 (when
configuring the second pump) and press F2 .
5. In the Device Configuration dialog box, under Mode , select
DeviceControl and click OK . The solenoid valve 9 (or 10) connector
on the main SP electronics board is now assigned to control the
peristaltic pump rather than a solenoid valve.
6. Save the configuration.
Figure E-9. Fitting Nut and Ferrule for Peristaltic Tubing Connections