Thermo Scientific Dionex, Operator'S Manual

Page: 191 / 228

D • AE Purge Kit Installation Instructions
Doc. 065250-06 03/2020
179
D.2.2 Installing the Purge Orifice/Spark Arrestor and the
Pressure Relief Valve
1. Follow the instructions in the manual provided with the purge control
system to install the purge orifice in the spark arrestor. Use the
smallest orifice provided with the purge control system.
2. Attach the assembled orifice/spark arrestor to its mounting panel (see
Figure D-10 , View A).
3. Attach the pressure relief valve to its mounting panel (see
Figure D-10 , View B).
4. Remove the cover plates from any two small rectangular openings on
the AE, LE, or SP enclosure. The available locations depend on the
configuration of enclosures installed in the system.
NOTE If the AE is mounted on the wall and an SP is
mounted on the right side of the AE, install the
orifice/spark arrestor on the bottom of the SP or on
the bottom rear of the AE.
5. Install the purge orifice/spark arrestor and the pressure relief valve in
the two rectangular openings. In the example installation shown in
Figure D-10. Purge Orifice and Relief Valve on Mounting Panels
Purge Orifice/Spark
Arrestor
Purge Relief
Valve
A
B