Thermo Scientific Dionex, Operator'S Manual

Page: 104 / 228

Dionex Integral Systems Operator’s Manual
92
Doc. 065250-06 03/2020
Notes
•
Commands for the SP and SS must be added in the Script Editor view
in the Instrument Method Editor. Commands for other Dionex
Integral system components can be added in the Instrument Method
Wizard.
•
To ensure that sample preparation works correctly, method
commands must be grouped into one block of commands for the SP
and another for the SS. The
BeginSPSamplePrep command must be
the first command in the block, while the EndSPSamplePrep
command must be the last command. For more information, refer to
the Chromeleon 7 Help.
In Chromeleon 7 PA:
•
Configure the Dionex Integral analyzers, instruments, and streams.
Refer to the Chromeleon 7 PA Help for detailed instructions.
7.3 Routine Startup and Operation
Routine operation consists of first confirming that all hardware is operating
properly, and then running instrument methods and sequences to control sample
analysis. Refer to the Chromeleon 7 PA Help for detailed operating instructions.
7.3.1 Routine Startup
1. Confirm that the power is on for all system components.
2. Confirm that the computer is on.
3. Check that the Chromeleon 7 Server is running.
4. Confirm that all water and gas utilities are on and adjusted to their
proper pressures.
5. Confirm that all mobile phases, standards, and reagents are supplied.
6. Start Chromeleon 7 PA.
7. Load an appropriate sequence.
8. Verify the following:
•
The mobile phase flow rates are correct.