Thermo Scientific Dionex, Operator'S Manual

Page: 152 / 228

Dionex Integral Systems Operator’s Manual
140
Doc. 065250-06 03/2020
10.10 Calibrating Components
Chromeleon provides commands for calibrating the components in a Dionex
Integral system.
1. Open the ePanel in Chromeleon 7.
2. Click the button for the calibration to be performed (for example, click
Dilution Pump Calibration to calibrate the dilution pump). A window
appears.
3. Follow the instructions in the window to complete the calibration.
NOTE The peristaltic loading pump, if installed, does not
require calibration. Adjusting the speed of the pump
delivers the required flow rate (see
Section 10.9 ).
10.11 Changing the SP or SS Main Power Fuses
1. Turn off the SP or SS power switch.
2. Disconnect the power cord.
3. If the SP or SS is mounted on the side of an AE, remove the enclosure from
the AE to access the fuse drawer. For instructions, refer to Installation
Requirements and Customer Responsibilities: Process Analytical Systems
(Document No. 070186).
HIGH VOLTAGE—Disconnect the main power cord from its source and
also from the rear panel of the SP/SS.
HAUTE TENSION—Débranchez le cordon d'alimentation principal de
sa source et du panneau arrière du SP/SS.
HOCHSPANNUNG—Ziehen Sie das Netzkabel aus der Steckdose und
der Netzbuchse auf der Rückseite des SP/SS.