Operating Basics
2–2
VX1410 IntelliFrame Instruction Manual
The On/Standby switch on the top-left corner of the front panel applies DC
voltages to the mainframe. The switch is a momentary contact switch. The
switch is lighted when DC voltages are applied to the mainframe. You can also
remotely power on or power down the mainframe.
You can configure your mainframe to bypass the On/Standby switch (refer to
Remote Power Switch Configuration in Appendix B of this manual for informa-
tion on configuring the power switch). The On/Standby switch remains lighted
while power is applied; however, the switch itself no longer controls the
mainframe.
If you ordered your VX1410 IntelliFrame with the Enhanced Monitor (Op-
tion 1M), the mainframe includes a 20-character alphanumeric display indicating
the status of the system (see Figure 2–2). The NEXT and PREV push buttons on
the side of the display allow you to scroll through the display selections.
Power Switch
Figure 2–2: Partial Front View of the VX1410 IntelliFrame with Option 1M
Figure 2–3 shows the rear view of the standard VX1410 IntelliFrame.
The AC power connector is located on the bottom left side on the rear of the
mainframe. The AC fuse holder is located just above the power connector.
The chassis ground screw (if installed) can be used to connect multiple
mainframes to a common ground point.
The fan filter is located on the back of the mainframe. The filter slides easily into
the mainframe; there is no need to remove any covers to replace or clean the fan
filter.
Standard Monitor
The Fan Speed switch controls the speed of the system cooling fan. When the
switch is set to the VAR (variable) position, the mainframe automatically
controls the speed of the fan depending on the air temperature and amount of
cooling required by the modules. When the switch is in the FULL position, the
fans operate at full speed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
