Getting Started
1–16
VX1410 IntelliFrame Instruction Manual
7. Select the mounting method according to the rack type.
To mount the slide-out tracks with the front and rear flanges outside of the
front and rear rails, use method A shown in Figure 1–8 when doing step 8.
Add a bar nut to the installation only if the rails have untapped holes.
To mount with front and rear flanges inside of the rails, use mounting
method B shown in Figure 1–8 when doing step 8. This mounting method
assumes untapped holes.
8. Using the mounting method determined from the previous step, secure the
right slide-out track assembly to the front and rear rails. Seat the screws
fully, but lightly, to adjust the mounting later.
9. Tighten the screws left loose in step 4 to fix the front to rear flange spacing
of the slide-out track assembly.
10. Repeat steps 6 through 9 to mount the left slide-out track assembly.
Mounting Method A
Mounting Method B
Left-Front Rail
Left Slide-Out Track
Left Slide-Out Track
Use two flat head screws if the cabinet
rails have countersunk mounting holes;
otherwise use two pan head screws.
Use a bar nut if front
rails are not tapped.
10-32 Flat Head
Screw (4)
10-32 Pan
Head Screw (4)
10-32 Pan Head
Screw (4)
Left-Front Rail
Figure 1–8: Installing the Slide-Out Track Assemblies in the Rack (Top View)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
