Maintenance
VX1410 IntelliFrame Instruction Manual
7–11
The nut rails at the top and the bottom of the front of the VX1410 IntelliFrame
allow the user to securely install the modules in the mainframe by screwing the
top and bottom of the modules to the front of the mainframe. Refer to Figure 7–8
to remove these nut rails.
1. Loosen all module retaining screws (it may be necessary to slide the modules
partially out of the mainframe).
2. Remove the 12 screws holding the top cover to the mainframe using a
3/32-inch Allen wrench.
3. Slide the top cover of the mainframe back far enough to expose the hole just
inside the top and bottom extrusions.
4. Slide the nut rail out of hole on the side of mainframe.
Replace the nut rail by sliding it back in the side of the mainframe and pushing it
into place.
Remove module
retaining screws.
Nut Rail
Top Cover
Nut Rail
8-32 Screws (12)
Figure 7–8: Replacing the Top and Bottom Nut Rails
Procedure 5: Replacing
the Top and Bottom Nut
Rails
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com