Flow Sampling Commands
4-103
4
Flow sampling (sFlow) can be used with a remote sFlow Collector to provide an
accurate, detailed and real-time overview of the types and levels of traffic present on
the network. The sFlow Agent samples 1 out of
n
packets from all data traversing the
switch, re-encapsulates the samples as sFlow datagrams and transmits them to the
sFlow Collector. This sampling occurs at the internal hardware level where all traffic
is seen, whereas traditional probes only have a partial view of traffic as it is sampled
at the monitored interface. Moreover, the processor and memory load imposed by
the sFlow agent is minimal since local analysis does not take place
Table 4-25 show snmp user
- display description
Field
Description
EngineId
String identifying the engine ID.
User Name
Name of user connecting to the SNMP agent.
Authentication Protocol
The authentication protocol used with SNMPv3.
Privacy Protocol
The privacy protocol used with SNMPv3.
Storage Type
The storage type for this entry.
Row Status
The row status of this entry.
SNMP remote user
A user associated with an SNMP engine on a remote device.
Table 4-26 sFlow Commands
Command
Function
Mode
Page
sflow
Enables sFlow globally for the switch
GC
4-104
sflow source
*
* Due to the switch’s hardware design, these commands can only be enabled for specific port groups (1-8, 9-16,
17-24, 25-32, 33-48). However, sampling for each of the Gigabit combination ports (25-28/49-52) can be controlled
individually.
Enables sFlow on the source ports to be monitored
IC
4-104
sflow sample
*
Configures the packet sampling rate
IC
4-105
sflow polling-interval
Configures the interval at which counters are added to the
sample datagram
IC
4-105
sflow owner
Configures the name of the receiver
IC
4-106
sflow timeout
Configures the length of time samples are sent to the
Collector before resetting all sFlow port parameters
IC
4-106
sflow destination
Configures the IP address and UDP port used by the Collector IC
4-107
sflow max-header-size
Configures the maximum size of the sFlow datagram header IC
4-107
sflow max-datagram-size Configures the maximum size of the sFlow datagram payload IC
4-108
show sflow
Shows the global and interface settings for the sFlow process PE
4-108
Summary of Contents for 6152PL2 FICHE
