![background image](http://html.mh-extra.com/html/smc-networks/6152pl2-fiche/6152pl2-fiche_management-manual_1300644471.webp)
SNMP Commands
4-93
4
This command specifies the recipient of a Simple Network Management Protocol
notification operation. Use the
no
form to remove the specified host.
Syntax
snmp-server host
host-addr
[
inform
[
retry
retries
|
timeout
seconds
]]
community-string
[
version
{
1
|
2c
|
3
{
auth
|
noauth
|
priv
} [
udp-port
port
]}
no snmp-server host
host-addr
•
host-addr
- Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
•
inform
-
Notifications are sent as inform messages. Note that this option is
only available for version 2c and 3 hosts. (Default: traps are used)
-
retries
- The maximum number of times to resend an inform message if
the recipient does not acknowledge receipt. (Range: 0-255; Default: 3)
-
seconds
- The number of seconds to wait for an acknowledgment before
resending an inform message. (Range: 0-2147483647 centiseconds;
Default: 1500 centiseconds)
•
community-string
- Password-like community string sent with the
notification operation to SNMP V1 and V2c hosts. Although you can set this
string using the
snmp-server host
command by itself, we recommend that
you define this string using the
snmp-server community
command prior
to using the
snmp-server host
command.
(Maximum length: 32 characters)
•
version
- Specifies whether to send notifications as SNMP Version 1, 2c or
3 traps. (Range: 1, 2c, 3; Default: 1)
-
auth
|
noauth
|
priv
- This group uses SNMPv3 with authentication, no
authentication, or with authentication and privacy. See ?$paratext>? on
page 3-49 for further information about these authentication and
encryption options.
•
port
- Host UDP port to use. (Range: 1-65535; Default: 162)
Default Setting
• Host Address: None
• Notification Type: Traps
• SNMP Version: 1
• UDP Port: 162
Command Mode
Global Configuration
Command Usage
• If you do not enter an
snmp-server host
command, no notifications are sent.
In order to configure the switch to send SNMP notifications, you must enter at
least one
snmp-server host
command. In order to enable multiple hosts, you
must issue a separate
snmp-server host
command for each host.
Summary of Contents for 6152PL2 FICHE
