![background image](http://html.mh-extra.com/html/smc-networks/6152pl2-fiche/6152pl2-fiche_management-manual_1300644626.webp)
Command Line Interface
4-248
4
Link Aggregation Commands
Ports can be statically grouped into an aggregate link (i.e., trunk) to increase the
bandwidth of a network connection or to ensure fault recovery. Or you can use the
Link Aggregation Control Protocol (LACP) to automatically negotiate a trunk link
between this switch and another network device. For static trunks, the switches have
to comply with the Cisco EtherChannel standard. For dynamic trunks, the switches
have to comply with LACP. This switch supports up to four trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate bandwidth of
4 Gbps when operating at full duplex.
Guidelines for Creating Trunks
General Guidelines –
• Finish configuring port trunks before you connect the corresponding network
cables between switches to avoid creating a loop.
• A trunk can have up to eight ports.
• The ports at both ends of a connection must be configured as trunk ports.
• All ports in a trunk must be configured in an identical manner, including
communication mode (i.e., speed, duplex mode and flow control), VLAN
assignments, and CoS settings.
• Any of the 100BASE-TX ports can be trunked together. Any of the
1000BASE-TX ports (Ports 25-28/49-52) can also be trunked together,
including those of different media types.
• All the ports in a trunk have to be treated as a whole when moved from/to,
added or deleted from a VLAN via the specified port-channel.
Table 4-58 Link Aggregation Commands
Command
Function
Mode
Page
Manual Configuration Commands
interface port-channel
Configures a trunk and enters interface
configuration mode for the trunk
GC
4-221
channel-group
Adds a port to a trunk
IC (Ethernet)
4-249
Dynamic Configuration Command
lacp
Configures LACP for the current interface
IC (Ethernet)
4-250
lacp system-priority
Configures a port's LACP system priority
IC (Ethernet)
4-251
lacp admin-key
Configures a port's administration key
IC (Ethernet)
4-252
lacp admin-key
Configures an port channel’s administration key IC (Port Channel)
4-253
lacp port-priority
Configures a port's LACP port priority
IC (Ethernet)
4-254
lacp active/passive
Configures active or passive LACP initiation mode IC (Ethernet)
4-255
Trunk Status Display Command
show interfaces status
port-channel
Shows trunk information
NE, PE
4-230
show lacp
Shows LACP information
PE
4-255
Summary of Contents for 6152PL2 FICHE
