SMC Networks 6152PL2 FICHE, Management Manual

Page: 590 / 818

Command Line Interface
4-212
4
Example
Related Commands
ipv6 access-group (4-211)
The commands in this section configure ACLs based on the IP or MAC address
contained in ARP request and reply messages. To configure ARP ACLs, first create
an access list containing the required permit or deny rules, and then bind the access
list to one or more VLANs using the
ip arp inspection vlan command (page 4-192).
This command adds an ARP access list and enters ARP ACL configuration mode.
Use the
no form to remove the specified ACL.
Syntax
[ no ] access-list arp acl_name
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
To create an ACL, you must add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
• An ACL can contain up to 32 rules.
Table 4-52 ARP ACL Commands
Command Function Mode Page
access-list arp Creates a ARP ACL and enters configuration mode GC 4-212
permit, deny Filters packets matching a specified source or destination
address in ARP messages
ARP-ACL 4-213
show arp access-list Displays the rules for configured ARP ACLs PE 4-214