SMC Networks 6152PL2 FICHE, Management Manual

Page: 298 / 818

Configuring the Switch
3-242
3
CLI – This example shows the switch configured with primary VLAN 5 and
community VLAN 6. Port 3 has been configured as a promiscuous port and mapped
to VLAN 5, while ports 4 and 5 have been configured as host ports and associated
with VLAN 6. This means that traffic for port 4 and 5 can only pass through port 3.
Use the Private VLAN Port Configuration and Private VLAN Trunk Configuration
menus to set the private VLAN interface type, and assign the interfaces to a private
VLAN.
Command Attributes
• Port/Trunk – The switch interface.
• PVLAN Port Type – Sets the private VLAN port types.
- Normal – The port is not assigned to a private VLAN.
- Host – The port is a community port. A community port can communicate with
other ports in its own community VLAN and with designated promiscuous
port(s).
- Promiscuous – A promiscuous port can communicate with all interfaces within
a private VLAN.
• Primary VLAN – Conveys traffic between promiscuous ports, and between
promiscuous ports and community ports within the associated secondary VLANs.
If PVLAN type is “Promiscuous,” then specify the associated primary VLAN.
• Community VLAN – A community VLAN conveys traffic between community
ports, and from community ports to their designated promiscuous ports. Set
PVLAN Port Type to “Host,” and then specify the associated Community VLAN.
• Trunk – The trunk identifier. (Port Information only)
Console#show vlan private-vlan 4-326
Primary Secondary Type Interfaces
-------- ----------- ---------- ------------------------------
5 primary Eth1/ 3
5 6 community Eth1/ 4 Eth1/ 5
Console#