Simex multicon cmc-141, User Manual

Page: 134 / 300

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
– Shape parameter set as slope ,
– in Final value parameter write 10 ,
◦ press green button on the bottom left side of the screen,
◦ Section num. parameter should be set as 2 ,
– in
Duration
parameter write
2
,
–
Unit
parameter set as
second
,
–
Shape
parameter set as
const.value
,
– in Final value parameter write 8 ,
◦ press green button on the bottom left side of the screen,
◦ Section num. parameter should be set as 3 ,
– in
Duration
parameter write
3
,
–
Unit
parameter set as
second
,
–
Shape
parameter set as
slope
,
– in Final value parameter write 4 ,
◦ press green button on the bottom left side of the screen,
◦ Section num. parameter should be set as 4 ,
– in Duration parameter write 1 ,
–
Unit
parameter set as
second
,
–
Shape
parameter set as
const.value
,
– in Final value parameter write 4 ,
• Looping parameter set as disabled ,
– for Displaying block parameters:
•
Format
parameter set as
numeric
,
•
Precision
parameter set as
0.0
,
• in
Graph low
write
0
,
• in Graph high write 10 ,
Configuration of logical channel 2 (Triggering source) in Hardware input mode for
current input is shown in 7.8.11.1. Application of Logical channel in the Hardware input
mode for UI4 module
(for this mode we configure logical channel 2 in this task).
Second method is shown in 7.12.4.1. Application of the Profiles/timers .
134