User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
Note on the update:
–
do not power off the device or remove the flash drive from the USB port during the
update,
–
the update process must go continuously to the end, the user will be informed of the
progress throughout the update cycle;
Attention! The user can not start an unfinished update again because this may
damage the device,
–
there can not be more than one update file on a flash drive,
–
update files must reside in the main folder (root of the drive),
–
the update process may take about 5 minutes, depend on the version of the device.
The requirements for removable flash drives are presented in
Chapter 7.3. FILES
The
Remote display
button allows the MultiCon to communicate with the PC to display the
screen of the
MultiCon
on the PC monitor to configure and view the data.
This button is available only for devices with installed ACM or ETU module.
Below please find a step by step description of how to configure the
MultiCon
with a PC.
1.
Download free “
Xming
” software from
http://sourceforge.net/projects/
xming/files/Xming/6.9.0.31/Xming-6-9-0-31-setup.exe/download
2.
Install “
Xming
” on your PC using default settings. During installation enable create a
desktop icon for “
Xming
” option and disable “
Launch Xming
” option.
3.
After installation of "
Xming
" use the right mouse button to open the properties
window for desktop icons of the "
Xming
" and replace the “
-multiwindow”
with
“
-ac -kb -notrayicon -screen 0 900+400”
, then close the window
properties. “
Xming
" in cooperation with the
MulitCon
device allows to change the
following parameters selected below:
Fig. 7.26 Xming parameters description
Screen number in "
Xming"
should be set the same as the value of the
Screen number
parameter in
Network settings
submenu in
MultiCon
device (see below the point
5
).
4.
Next close the window properties and run “
Xming
” using desktop icon.
5.
In “
Network settings
” of the device in the group "
Remote Display
" enter the
IP address
of your computer and “
Screen number=0"
, then exit menu and save
configuration changes.
6.
In the “
Device information
” menu press the “
Remote display
” button and confirm
switching to remote display. After a while the device screen will be redirected to your
computer screen.
54
i
xming.exe :0 -ac -kb -notrayicon -screen 0 900+400
Screen number (0÷9)
Shift the screen by 900 pixels to the right and 400 pixels down,
