Simex multicon cmc-141, User Manual

Page: 65 / 300

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
– CSV Format settings parameter block – contains parameters which are related with
creating and sending CSV files,
•
Decimal separator – selects decimal separator in CSV files for numeric values,
◦ dot – decimal separator is a dot and a comma will separate all fields in CSV
files,
◦
comma
– decimal separator is a comma and a semicolon will separate all
fields in CSV files,
– Remote shutdown parameter block – allows to set automatic shutdown of the
device,
•
Mode – turns on and off shutdown from logical channel,
◦ disable – remote shutdown is off,
◦ from log. channel – remote shutdown is on,
•
Triggering source
– contains the logical channels list, where selected one will
be source for the remote shutdown; the shutdown procedure will start each time
when signal in selected channel will change from value
≤
0 to value > 0 ,
• Delay – settable time that will pass before the device will shutdown; this
procedure will be stopped if during this time:
◦
signal in Triggering source parameter will drop to
≤
0 value,
◦ the user will press
cancel
button on the screen,
When device starts or when in Remote shutdown parameter block has been
made any changes and in selected channel in Triggering source parameter is
value greater than 0, the shutdown procedure won't start. To start shutdown
procedure, value in this channel must change to value equal or lower than 0 and
then to value greater than 0.
Setup list
parameter
After pressing the
Setup list
button the user enters the
View
menu allowing the creation of
1 to 20 views.
Arrows placed in the upper right corner of the screen allow you to
move to the next view. The middle button allows you to directly select a
particular view.
Parameters of View menu are:
– Display mode - this parameter allows the user to select the presentation of the data
in the displayed group (see parameter:
Displayed group
). For possible modes see
Chapter 6.3.3. Data panels
and
Chapter 7.14. GROUPS
,
– Displayed group - allows the user to select a group displayed at startup. If the
Display mode is chosen as many groups , parameter Display group selects the
first of five following groups displayed on the screen (mode many group presents 5
groups in one window). For example, when setting the parameter to
Display group=Group 8 then the display will show: starting from the left side of:
Group 8 -> Group 9 -> Group 10 -> Group 1 -> Group 2,
–
Display time
- this parameter is visible for the
Triggering mode
:
by time
, it sets the
duration (in seconds) of the selected view,
– Add a new view button - adds a new view to the list
– Delete this view button - deletes selected view from the list,
– Move to position - this parameter allows the user to move the current view to the
appropriate position,
65
i