Simex multicon cmc-141, User Manual

Page: 47 / 300

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
7.3. FILES MANAGEMENT
Fig. 7.15. This button allows to entry to the files management menu
After pressing MENU -> Files management (see Fig. 7.15 ) opens the files
management menu which is used to exchange data with a flash drive.
Requirements for a flash drive:
– Maximum current consumption is 100mA. Some flash drives with large capacities are
not supported by the device (in this case can use an external USB hub with power
supply). The manufacturer recommends the use of flash drives of 2GB in size.
– The flash disk must be formatted for Windows as FAT (NOTE!! not FAT32).
– update files, configurations files, and Modbus templates must be located in the main
folder (the root of the drive).
A view of the File management menu is shown in Fig. 7.16 . There are four buttons
called Logging files , Configuration files , Permission files and Printer files .
The
Logging files
button is always visible and it contains all possible parameters but
their functionality is blocked until the licence key for data logging is entered (more information
about the licence key is located in
Chapter 7.4. ). The Configuration files button is visible
and active always. The Permission files button is available when Access mode parameter
in Access options menu is set as MultiLevel (see Chapter 7.17. ). Printer files button is
always visible but this functionality is active only when MultiPrint MLP-149 printer is
connected to the device.
Fig. 7.16. Files management menu
Logging files:
The
Logging files
button (see
Fig. 7.16
) opens the logging files management menu
(see
Fig. 7.17
). To export and/or delete logged files follow these steps:
– select a file/s of logged data from a group,
– select the more files in the other groups (if needed),
– export selected files to flash drive and / or delete selected logged data files,
47