Simex multicon cmc-141, User Manual

Page: 109 / 300

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
7.8.9. Logical Channels - Profile/timer (cycle counter) mode
This mode is similar to Profile/timer mode but instead of using the signal generated by
the Profile/timer, the number of cycles elapsed by the profile is transferred to the logical
channel.
Cycle counter is generated depending on the Looping parameter value, ie when
Looping=disabled the cycle counter is equal to 0.
The parameters of the
Logical channel
in
Profile/timer (cycle counter)
mode should be:
– Name - it gives the name to the logical channel,
– Unit - for Built-in modules it will automatically use the default Unit , to change the
unit use the Scaling parameter in Processing parameter block, to create unit use
the Scaling parameter (for more information see Chapter 7.8.1. Logical Channels -
General settings
),
–
Mode=Profile/timer
- in this parameter user selects the source of data for the logical
channel,
– Source - this parameter allows the user to select a Profile/timer from the list
( 8 Profiles/timers are implemented in the device), the selected option will be the
data source for this logical channel.
– Configure source - this button allows the user to configure the Profile/timer
selected in the
Source
parameter. For more information see below in this
Chapter
,
–
Latch
parameter block - allows the user to set the
latch function
which will hold the
last value of a channel (discussed in Chapter 7.8.1. Logical Channels - General
settings ),
– Processing parameter block - is used for scaling and filtering data (discussed in
Chapter 7.8.1. Logical Channels - General settings ),
–
Displaying
parameter block - for these parameters the user selects the format and
range of the data displayed on the screen (discussed in
Chapter 7.8.1. Logical
Channels - General settings ),
Before selecting or after selecting the Prodfile/timer from the list inside the Logical
channel, the user must configure the selected Profile/timer by pressing the
Configure source
button or enter into the
Profiles/timers
menu,
109
i
i
disabled
Hardware input
Hardware output monitor
Modbus
Set point value
Math function
Controller
Profile/timer
Profile/timer (cycle counter)
Data from other channel
Logical channel Device configuration MENU
Mode