Simex multicon cmc-141, User Manual

Page: 179 / 300

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
– Triggering source – allows to choose triggering source of the Profile/timer from the
logical channel list,
– Idle value – the value which occurs at the idle state which means before and after
generating the Profile/timer,
– Section list – submenu in which the user can define up to 100 sections generated
by the Profile/timer. For more information see
Chapter 7.12.1. Profile/timer -
General settings
,
– Looping – each Profile/timer has an ability to repeat its generated signal, this
parameter has options:
•
disabled – the profile is not repeated,
• counted – allows to generate the profile specified number of times defined in
Loop count
parameter,
•
from logical channel
- allows to run the profile number of times equals the
value in the selected logical channel determined by the Looping source
parameter,
• infinite – allows to infinite repeating of generated Profile ,
– Loop count – this parameter is visible only if Looping parameter is set as counted ,
defines the number of repetitions of generated Profile,
–
Looping source
– this parameter is visible only if
Looping
parameter is set as
from logical channel
. It allows to choose a logical channel from the list, which value
will be compared with the number of already made cycles of Profile,
– Return to position – this parameter is invisible if Looping parameter is set as
disabled , allows to select a fixed position from which every next generated Profile
has to start,
Fig. 7.102. Sample of Profile/timer
179
1 2 3 4 5 6
Profile
Time [s]
Idle value
Section num.: 1 2 3 4 5