Simex multicon cmc-141, User Manual

Page: 146 / 300

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
TC modules parameters are:
– Name – each built-in input already has a name given by the device and user cannot
change it, for description of Name parameter see Fig. 7.75 .
– Unit – parameter which displays °C or mV , depending on Mode parameter settings,
–
Mode
– allows to set thermocouple which is used to measurements or voltage
measurement range,
–
Low limit
– defines measurement level bellow which in logical channel will be
displayed Lo state,
– High limit – defines measurement level above which in logical channel will be
displayed Hi state,
–
Wire compensation
– menu which allows to compensate measurement errors,
which can be caused by wrong sensor readings,
•
Compensation mode
– allows to choose parameter, which will be used in
compensation process,
◦
disable – compensation is not active,
◦ manual – allows to compensate sensor constant offset,
– Compensation – parameter which allows tu manually compensate
sensor error, written here value will be added or subtracted from
measured sensor value,
◦
automatic
– allows to compensate the difference between real temperature
and that measured by the sensor,
–
Actual temperature – parameter in which user enters actual
temperature near the sensor, which is measured by more reliable
thermometer,
– Compensate – button which activates the compensation; value which
is written in Actual temperature parameter will be from now on used for
compensation,
–
Compensation
– read only parameter; displays voltage value
calculated to compensate temperature measurement,
User should remember, that after changing the sensor, new settings in
Wire compensation
menu should be made.
Connectors temperature input parameters are:
– Name – each built-in input already has a name given by the device and user cannot
change it, for description of Name parameter see Fig. 7.75 .
–
Unit
– parameter which displays
°C
,
–
Mode
– parameter which displays “
Temp. of connectors
”,
– Low limit – defines measurement level bellow which in logical channel will be
displayed Lo state,
– High limit – defines measurement level above which in logical channel will be
displayed Hi state,
–
Offset
– parameter which allows to add or subtract constant value to temperature
measured by connectors temperature sensor,
146